How to connect 2 system using LAN




1 step: - you have a cable his name is
TIA/EIA 568-B.2 CATEGORY 5e
And RJ45 connector
2step: - make a cross cable

1st point 2nd point of cable wires
1--------3
2--------6
3--------1
4--------4
5--------5
6--------2
7--------7
8--------8
Cable each wires setting.
3 steps: your computer have install Ethernet hardware
How to
Right click "my computer"
Move mouse "computer properties"
Click "hardware" tab menu
Click "Device Manager"
Device manager window is open
Check network adapter
"PCI Fast Ethernet NIC" is work or not?
If NIC device is work then do next work
Else Nick device have cross simple then double click NIC device.
And "Enable Device"
Device usage: use this device (enable)


End work
next
4 steps. Create a ip address to both system are not same (My network places)
Click: - "view network connections" in network tasks
Right click: - local area connection
Ex: Realtek RTL8139 family PCI
Click: properties
Click 'this connection uses the following item:'
Internet protocol (TCP/IP) click "properties"
Use the following IP address
Ex: -
1st PC 192.168.0.100
Subnet mask 255.255.255.0
2nd Pc 192.168.0.200
Subnet mask 255.255.255.0
Click "ok" "ok"
4 steps: dos command check connection
Ping ip address (other pc)
Ex: ping 192.168.0.100
They have checking connection
And massage report
5.click in network task Firwall setting change
Off (not recommended) both system.
6-check group are same in my computer properties "computer Name"
Ex: "workgroup"
7. Then plug in cable to computer pc1 pc2.
Then massage is display "network cable is plugging with 100mbps"
Then click "network placese" and click "view workgroup computer"


Note:
Windows Xp any new
1.568 cable is make in cross 1---3,2----6,3----1,6-----2
2.same work group name
3.if you have problem to generate to ip address so this is not important to computer because automatically assign ip address
4.if Ethernet is not work/ not install
You have installed it with "main board" cd
Insert cd in cd Rom click "my computer" "properties" "hardware" "device manager"
Right click NIC device and choose update device click next to fowling instruction.
5.firwall setting, anti viruse firewall setting.
6. Ms dos command ping is must be using.
Ping command using in dos
If massage is Request timed out.
So you have a cable problem.
Of work group problem.

Comments

Popular posts from this blog

Tips 01) self introduction in an interview

Computer Science Terminology

Why Failure Is Good for Success